#Honda hds for 2007 driver
#Honda hds for 2007 code

If low tire pressure and a problem in the system are detected, only the TPMS indicator comes on. If a problem is detected in the system, the TPMS indicator will come on. See the appropriate manufacturer service information. If the warning light is still lit, or the TPMS indicator is lit continuously, there is a problem in the TPMS. The light will remain on until tire pressure is properly set. If low tire pressure indicator is lit continuously, due to low pressure in one or more tires, adjust tire inflation to proper pressure as indicated on the tire and loading information placard. NOTE: If the outside temperature is at or below -40В° F (-40В° C), the system may not function properly. Then explain to the customer how temperature changes can affect the system, especially when tire pressures are near the low end of the TPMS normal range - 24 to 32 psi (168 to 220 kPa). To resolve a complaint of such intermittent indications, confirm and clear the stored DTC(s) and check the tire pressures. If the temperature drops and then rises, tire pressure could decrease just enough to turn on the low pressure and tire(s) indicators, but later increase enough to turn them off. A temperature change of about 18 degrees Fahrenheit (10 degrees Celsius) will change tire pressure by about 1.5 psi (10 kPa). Pressures will also increase or decrease slightly with changes in outside air temperature. NOTE: Tire pressures will increase slightly as the temperature in the tires rises during driving at highway speeds. Sensor memorization after normal tire rotation is not necessary. Each low pressure sensor has its own ID to prevent jamming by similar systems on other vehicles.ДЄfter memorizing all the sensor ID(s), the control unit receives only those specific signals.

The unit is attached to the inside of the wheel, around the valve stem. Each sensor is an integrated unit made up of the tire valve stem, a pressure sensor, and a transmitter. If the TPMS control unit loses power or fails, the TPMS indicator will come on, but no DTC will be set.

#Honda hds for 2007 driver

When the system detects a problem, the TPMS control unit sets a code, but shifts to fail-safe mode, and does not alert the driver to low tire pressures. When the tire pressure is increased to more than 28 psi (190 kPa) and the vehicle is driven above 28 mph, the control unit will turn off the indicators and store the DTC(s).

#Honda hds for 2007 code

If it detects less than 24 psi (168 kPa) in a tire, it alerts the driver by turning on the low pressure indicator and setting a diagnostic trouble code (DTC) in the control unit. Whenever the vehicle speed exceeds 28 mph, the tire pressure monitoring system (TPMS) control unit in 2007 to 2013 Honda CR-Vs monitors all four tires and the system itself. After memorizing the sensor ID(s) or doing a tire rotation, the mounting location of sensors 1, 2, 3 and 4 must be determined. NOTE: When a tire pressure sensor or control unit is replaced on a 2007-2013 Honda CR-V, or a known-good wheel is substituted, the ID(s) of all four tiresвЂ™ sensors must be memorized by the TPMS control unit. The TPMS sensor tool (AKS0620006) has been superseded by the ATEQ VT55 tool, and is recommended for use on all Honda vehicles. The Honda diagnostic system (HDS) or an OBD-II compatible scan tool and an ATEQ VT55 tool (recommended), or the TPMS sensor tool AKS0620006 must be used to program information into new TPMS control unit with both of the reset procedures. SUBJECT VEHICLES: 2007 to 2013 Honda CR-V.